Smeg washer error codes

Smeg SLB600 washer error codes


Number of times the “End” programmer phase LED flashes between two 15 second intervalsProblem
5The tub does not fill with water
Consult the troubleshooting table at point: 2
6The water does not drain from the tub
Consult the troubleshooting table at points: 4 and 5
1A leak has occurred and Aquastop has triggered (only for models fitted with this safety device)
For this type of error, turn off the water tap, remove the plug and contact the Service Centre.

SMEG WM639 washer error codes


FAILURE CODEFAILURE INDICATORPROBABLE FAILURETHE PROCESS TO BE DONE
Err 01The start/pause light blinks.The door is not shut properly.Shut the door properly so that you hear the click. If the problem persists, turn off the machine unplug and apply to the nearest authorized service immediately.
Err 02The program ready light blinks.The water level in your machine is below heater. The pressure of your water supply may be low or locking.Turn on the tap to the end. Water may be cut, check it. If the problem is still continuing, your machine will automatically stop after a while. Unplug your machine, turn off the tap and apply to the nearest authorized service.
Err 03The start/pause light and program ready light blinks .The pump has failed or the pump filter is obstructed.Clean the pump filter. lf the problem persists, apply to the nearest authorized service. (*)
Err 05The start/pause light and program end light blink.The heater of your machine or the heat sensor has failed.Shut down your machine and unplug. Turn off your tap and apply to the nearest authorized service.
Err 06The program ready light and program end light blink.The motor has failed.Shut down your machine and unplug. Turn off the tap and apply to the nearest authorized service.
Err 07The program start/pause light, ready light and program end light stays on permanently.Configuration error.Shut down your machine and unplug. Turn off the tap and apply to the nearest authorized service.
Err 08The start/pause light program ready light and program end light blink.The motor has failed.Shut down your machine and unplug. Turn off the tap and apply to the nearest authorized service.
Err 09The program ready light and program end light stays on permanently.The network voltage is too high or too low.If the network voltage is lower than 150V or higher than 260V, your machine will automatically stop. When the network voltage is recovered, your machine will continue its operation.

Smeg WMF16AX1 error codes

Error codeProblem
ENDDoor not closed properly. Close it.
E1Aquastop. Contact the nearest Service Centre after disconnecting the machine from the electrical power supply and closing the water tap.
E5No water for washing. See point 2 on the troubleshooting table.
E6The water does not drain. See point 4 on the troubleshooting table.