Troy bilt pressure washer troubleshooting

Pressure washers found application not only among motorists, as an alternative to urban car washes in general use, but also in everyday life. This refers to pressure washers Troy Bilt as well. One can remove pollution from pavements, garden paths, buildings or solve many other tasks with their help. The usability of everyday experience, bright design and a wide range of models allow even the most aggressively tuned buyers change their view of this kind of products fundamentally. In addition, there is a very useful troubleshooting table that comes to your assistance in case of any breakage.

ProblemCauseCorrection
Pump has following problems: failure to produce pressure, erratic pressure, chattering, loss of pressure, low water volume.1. Low pressure spray tip installed.1. Replace with high pressure spray tip.
2. Water inlet is blocked.2. Clear inlet.
3. Inadequate water supply.3. Provide adequate water flow.
4. Inlet hose is kinked or leaking.4. Straighten inlet hose, patch leak.
5. Clogged inlet hose screen.5. Check and clean inlet hose screen.
6. Water supply is over 100°F.6. Provide cooler water supply.
7. High pressure hose is blocked or leaks.7. Clear blocks in outlet hose.
8. Spray gun leaks.8. Replace spray gun.
9. Spray tip is obstructed.9. Clean spray tip.
10. Pump is faulty.10. Contact local service facility.
Detergent fails to mix with spray.1. Detergent siphoning tube is not submerged.1. Insert detergent siphoning tube into detergent.
2. Detergent siphoning tube is clogged or cracked.2. Clean or replace detergent siphoning tube.
3. High pressure spray tip installed.3. Replace with low pressure spray tip.
Engine runs good at no-load but "bogs" when load is added.Engine speed is too slow.Move throttle control to FAST position. If engine still "bogs down", contact local service facility.
Engine will not start; or starts and runs rough.1. Low oil level.1. Fill crankcase to proper level.
2. Dirty air cleaner.2. Clean or replace air cleaner.
3. Out of fuel.3. Fill fuel tank.
4. Stale fuel.4. Drain fuel tank; fill with fresh fuel.
5. Spark plug wire not connected to spark plug.5. Connect wire to spark plug.
6. Bad spark plug.6. Replace spark plug.
7. Water in fuel.7. Drain fuel tank; fill with fresh fuel.
8. Excessively rich fuel mixture.8. Contact local service facility.
Engine shuts down during operation.Out of fuel.Fill fuel tank.
Engine lacks power.Dirty air filter.Replace air filter.