Haier GWT700AW washing machine error codes
| Trouble Codes | Reason |
|---|---|
| EO | Top lid not closed during delay start sequence |
| El | Blockage of drain hose. |
| E2 | Top lid not closed during wash operation |
| E3 | The washer is out of balance |
| E4 | Water inlet valve closed |
| The water pressure is too low | |
| E5 | The water level sensor fault - Call service |
| E 7 | The communication fault - Call service |
Haier HAS1000TVE washing machine error codes
| Error code: | Cause: | Correction: |
|---|---|---|
| Err1 | Door is not properly shut | Shut the door properly. |
| Err2 | Drainage error, water not emptied within 4 minutes | Clean the filter and check the drain hose for blockage. If error still exists, please contact the maintenance personnel |
| Err3 | Temperature sensor not properly connected or damaged | Contact the maintenance personnel |
| Err4 | Heating coil damage or overload of laundry that leads to a failure to reach the set temperature within the specified time (This message is displayed at the end of a program). | Reduce load and then start washing again or contact the maintenance personnel |
| Err5 | Water level not met in 8 minutes | Make sure that tap is turned on, and water pressure is normal. If problem still exists, please contact the maintenance personnel |
| Err7 | Motor overheat protection or damage | Contact the maintenance personnel |
| Err8 | Water exceeds protective level | |
| End | A program ends | |
| 01:25 | The remaining time is 1hour 25 minutes |
Haier HBF601T washing machine error codes
| Error code: | Cause: | Correction: |
|---|---|---|
| Error 1: The door lock light does not illuminate | Door is not properly shut | Shut the door properly |
| Error 2: The door lock light glitters 2 times and stops 4 seconds repeatedly | Drainage error, water not emptied within 4 minutes | Clean the filter and check the drain hose for blockage. If error still exists, please contact the maintenance personnel |
| Error 3: The door lock light glitters 3 times and stops 4 seconds repeatedly | Temperature sensor not properly connected or damaged | Contact the maintenance personnel |
| Error 4: The door lock light glitters 4 times and stops 4 seconds repeatedly | Heating coil damage leads to a failure to reach the set temperature within the specified time (This message is display at the end of a program). | |
| Error 5: The door lock light glitters 5 times and stops 4 seconds repeatedly | Water level not met in 8 minutes | Make sure that tap is turned on, and water pressure is normal |
| If problem still exists, please contact the maintenance personnel | ||
| Error 6: The door lock light glitters 6 times and stops 4 seconds repeatedly | Timing control silicon damage | Contact the maintenance personnel |
| Error 7: The door lock light glitters 7 times and stops 4 seconds repeatedly | Motor overheat protection or damage | |
| Error 8: The door lock light glitters 8 times and stops 4 seconds repeatedly | Water exceeds protective level |