| "no hot" (no hot - I am not getting any hot water) | Check that the hot water supply has been turned on. |
| Your hot water supply may not be hot enough to maintain the selected water temperature. Select a lower wash temperature. |
| Check that the inlet hose filter is not blocked. |
| Check that the inlet hoses are not kinked or squashed. |
| Check that the inlet hoses have been connected to the correct taps. |
| The flow rate of the supply water may be too slow |
| "no Cld" (no cold - I am not getting any cold water) | Check that the cold water supply has been turned on. |
| Your cold water temperature may exceed the recommended limits |
| Check that the inlet hose filter is not blocked. |
| Check that the inlet hoses are not kinked or squashed. |
| Check that the inlet hoses have been connected to the correct taps. |
| The flow rate of the supply water may be too slow |
| "no tAP" (I am not getting any water) | Check that the taps have been turned on. |
| Check that the inlet hose filters are not blocked. |
| Check that the inlet hoses are not kinked or squashed. |
| Check to see if the drain hose is too low or is pushed into the standpipe too far. This will cause the water to siphon out of the machine. |
| The flow rate of the supply water may be too low |
| "out oF bAL" (out of balance) | Wash load is out of balance. |
| Ensure the machine is stationary and manually redistribute the load. |
| Check your machine is level |
| "Sud LOC" (suds lock –I have too many suds) | Your machine has a suds build-up. Too much detergent may have been used for the amount of soil in the load. |
| Ensure that you are using a HE, Low Sudsing, Matic or Front Loader type detergent. |
| Wait for suds to dissolve (about 20 minutes). |
| Restart the cycle from the start (do not add more detergent). |
| Check the standpipe height does not exceed 2400 mm. |
| If using the DUAL WASH option, reduce the amount of detergent placed in the detergent dispenser |
| "Lid LOC" or "Lid OPn" (lid lock or lid open - 1 can't lock the lid or the lid is open) | Check that the lid is closed. |
| Press START/PAUSE |
| If the symptom persists, call your Fisher & Paykel Authorised Repairer |
| "too FUL" (too full - I am overloaded) | Your machine is overloaded and cannot continue the cycle. |
| Ensure the machine is stationary and remove items until the remaining ones can move freely. Check that the machine is not siphoning |
