Haier washing machine error codes

Haier GWT700AW washing machine error codes

Trouble CodesReason
EOTop lid not closed during delay start sequence
ElBlockage of drain hose.
E2Top lid not closed during wash operation
E3The washer is out of balance
E4Water inlet valve closed
The water pressure is too low
E5The water level sensor fault - Call service
E 7The communication fault - Call service

Haier HAS1000TVE washing machine error codes

Error code: Cause:Correction:
Err1Door is not properly shutShut the door properly.
Err2Drainage error, water not emptied within 4 minutesClean the filter and check the drain hose for blockage. If error still exists, please contact the maintenance personnel
Err3Temperature sensor not properly connected or damagedContact the maintenance personnel
Err4Heating coil damage or overload of laundry that leads to a failure to reach the set temperature within the specified time (This message is displayed at the end of a program).Reduce load and then start washing again or contact the maintenance personnel
Err5Water level not met in 8 minutesMake sure that tap is turned on, and water pressure is normal. If problem still exists, please contact the maintenance personnel
Err7Motor overheat protection or damageContact the maintenance personnel
Err8Water exceeds protective level
EndA program ends
01:25The remaining time is 1hour 25 minutes

Haier HBF601T washing machine error codes

Error code: Cause:Correction:
Error 1: The door lock light does not illuminateDoor is not properly shutShut the door properly
Error 2: The door lock light glitters 2 times and stops 4 seconds repeatedlyDrainage error, water not emptied within 4 minutesClean the filter and check the drain hose for blockage. If error still exists, please contact the maintenance personnel
Error 3: The door lock light glitters 3 times and stops 4 seconds repeatedlyTemperature sensor not properly connected or damagedContact the maintenance personnel
Error 4: The door lock light glitters 4 times and stops 4 seconds repeatedlyHeating coil damage leads to a failure to reach the set temperature within the specified time (This message is display at the end of a program).
Error 5: The door lock light glitters 5 times and stops 4 seconds repeatedlyWater level not met in 8 minutesMake sure that tap is turned on, and water pressure is normal
If problem still exists, please contact the maintenance personnel
Error 6: The door lock light glitters 6 times and stops 4 seconds repeatedlyTiming control silicon damageContact the maintenance personnel
Error 7: The door lock light glitters 7 times and stops 4 seconds repeatedlyMotor overheat protection or damage
Error 8: The door lock light glitters 8 times and stops 4 seconds repeatedlyWater exceeds protective level