WasherErrorCodes

Many people consider Baumatic dishwashers rather reliable. However machines of even the most reliable brands can need repair every now and then. When something goes wrong, do not call a repair service at once: it may well happen that you can do the troubleshooting on your own using the list of Baumatic dishwasher error codes below.
To begin with, find the code in the first column. Having done this, you will be able to check the symptom as well as the cause of Baumatic dishwasher problems. After that it’s time to turn to the last column and try the suggested solutions for Baumatic dishwasher error codes.
Baumatic basic dishwasher error codes
Baumatic MG series dishwasher error codes

Baumatic basic dishwasher error codes

The Baumatic brand, which belongs to Candy Group since 2013, manufactures a wide range of basic dishwashers. There are both compact and standard sized models, integrated and free-standing versions. They can accommodate from 9 up to 16 place settings. Typically, they share the same system of error codes that are used to diagnose malfunctions.

CODE	SYMPTOM	CAUSE	WHAT TO DO
Err1	LONGER FILL TIME.	FAUCET IS NOT OPENED	Ensure that inlet hose is not kinked or crushed.
Err2	LONGER or EXTENDED DRAINING TIME	THE DRAIN PIPE WAS PLACED TOO HIGH WHEN IT WAS INSTALLED.
Err3	LONGER HEATING TIME – NOT REACHING REQUIRED TEMPERATURE	MALFUNCTION OF TEMPERATURE SENSOR OR OF HEATING ELEMENT.
Err4	OVERFILLED	TOO MUCH INLET WATER.	Overdosing. 3-in-1 put in with salt and/or rinse aid in the appliance overdose. Could also be a Water Pressure problem.
Err6	OPEN CIRCUIT	THERMISTOR.	Call for a qualified service technician
Err7	SHORT CIRCUIT

>

Baumatic MG series dishwasher error codes

One of the most popular dishwasher from the Baumatic MG series is the MG5. The model called Dance Partner has a stylish colorful design. There are several programs with wash temperatures ranging from 40°C to 60°C. Some of the useful features include a half load function, turbo drying, electronic aqua stop, and a delay timer.

Failure Code	Condition	Check/Repair
E1	Longer than expected fill time.	- Check the water pressure of your mains water supply. - Clean the mesh filter that sits in the inlet hose. - Ensure that the inlet hose is not kinked or crushed. - Make sure the water tap that the machine is connected to is turned on fully.
E2	Longer or extended drain time.	- The drain pipe may be placed in too high a position or incorrectly. Check the installation instructions and ensure that the installation is correct. - Check that the outlet hose is not kinked or crushed. - beyond its original length.
E3	Longer heating time- not reaching the required temperature.	- Malfunction of the temperature sensor or heating element. - Call Baumatic Service Department.
E4	The machine has sensed water in the base	- Check that the outlet hose is not kinked or crushed. - Check that there are no blockages in the drain hose or the drainage system that the appliance is connected to. - The drain pipe may be placed in too high a position or incorrectly. Check the installation instructions and ensure that the installation is correct. - Oversudsing being caused by a 3 in 1 detergent tablet being used with separate salt and/or rinse aid.
E5	Switch cannot shut off automatically - program not finishing its cycle	- Low voltage or power switch failure. - Call Baumatic Service Department.
E6	Open circuit	- Thermistor - Call Baumatic Service Department.
E7	Short circuit