Fisher Paykel washer error codes

Error code	Cause
"no hot" (no hot - I am not getting any hot water)	Check that the hot water supply has been turned on.
	Your hot water supply may not be hot enough to maintain the selected water temperature. Select a lower wash temperature.
	Check that the inlet hose filter is not blocked.
	Check that the inlet hoses are not kinked or squashed.
	Check that the inlet hoses have been connected to the correct taps.
	The flow rate of the supply water may be too slow
"no Cld" (no cold - I am not getting any cold water)	Check that the cold water supply has been turned on.
	Your cold water temperature may exceed the recommended limits
	Check that the inlet hose filter is not blocked.
	Check that the inlet hoses are not kinked or squashed.
	Check that the inlet hoses have been connected to the correct taps.
	The flow rate of the supply water may be too slow
"no tAP" (I am not getting any water)	Check that the taps have been turned on.
	Check that the inlet hose filters are not blocked.
	Check that the inlet hoses are not kinked or squashed.
	Check to see if the drain hose is too low or is pushed into the standpipe too far. This will cause the water to siphon out of the machine.
	The flow rate of the supply water may be too low
"out oF bAL" (out of balance)	Wash load is out of balance.
	Ensure the machine is stationary and manually redistribute the load.
	Check your machine is level
"Sud LOC" (suds lock –I have too many suds)	Your machine has a suds build-up. Too much detergent may have been used for the amount of soil in the load.
	Ensure that you are using a HE, Low Sudsing, Matic or Front Loader type detergent.
	Wait for suds to dissolve (about 20 minutes).
	Restart the cycle from the start (do not add more detergent).
	Check the standpipe height does not exceed 2400 mm.
	If using the DUAL WASH option, reduce the amount of detergent placed in the detergent dispenser
"Lid LOC" or "Lid OPn" (lid lock or lid open - 1 can't lock the lid or the lid is open)	Check that the lid is closed.
	Press START/PAUSE
	If the symptom persists, call your Fisher & Paykel Authorised Repairer
"too FUL" (too full - I am overloaded)	Your machine is overloaded and cannot continue the cycle.
"too FUL" (too full - I am overloaded)	Ensure the machine is stationary and remove items until the remaining ones can move freely. Check that the machine is not siphoning