Gorenje dishwasher error codes

You may be very disappointed when your Gorenje dishwasher stops working and shows a fault code. However, this situation gives you a chance to discover an engineering talent in yourself. Find the code in the list of Gorenje dishwasher error codes below and try the solutions offered. It may well happen that you are capable of resolving Gorenje dishwasher problems without any help and in much shorter time than you had expected.

Gorenje GV series, KGV series dishwasher error codes

Code	Problem	Repiar
E1	Dishwasher fails to fill with water If the pressure switch or sensor does not detect that the dishwasher has filled with water inside four minutes the buzzer will sound for thirty seconds and the LED will flash, the drain pump will then be run for sixty seconds and the program aborts.	Check water supply Check wiring to water valve Check wiring to pressure switch or sensor Check water valve Check pressure sensor or water level sensor
E2	Dishwasher not draining Dishwasher fails to detect that the water has drained out detected in four minutes, program aborted.	Check water drainage Check drain pump wiring Check drain pump
E3	Dishwasher times out when heating No heat detected in sixty minutes, program aborted.	Check wiring to heater and thermostats Check water heating element Check thermostats
E4	Aquastop protection circuit activated A micro-switch on the Aquastop leak detection system has been switched on for more than two minutes. The dishwasher will shut off the water inlet valve and drain the water aborting the program.	Check for water leaks Check float in the base of the dishwasher Check the Aquastop hose if fitted
E5	Not used
E6	Short circuit detected on the temperature sensor	Check water heating sensor wiring Check temperature sensor
E7	Temperature sensor detected as open circuit	Check water heating sensor wiring Check temperature sensor