Trouble Codes | Reason |
---|---|
EO | Top lid not closed during delay start sequence |
El | Blockage of drain hose. |
E2 | Top lid not closed during wash operation |
E3 | The washer is out of balance |
E4 | Water inlet valve closed |
The water pressure is too low | |
E5 | The water level sensor fault - Call service |
E 7 | The communication fault - Call service |
Error code: | Cause: | Correction: |
---|---|---|
Err1 | Door is not properly shut | Shut the door properly. |
Err2 | Drainage error, water not emptied within 4 minutes | Clean the filter and check the drain hose for blockage. If error still exists, please contact the maintenance personnel |
Err3 | Temperature sensor not properly connected or damaged | Contact the maintenance personnel |
Err4 | Heating coil damage or overload of laundry that leads to a failure to reach the set temperature within the specified time (This message is displayed at the end of a program). | Reduce load and then start washing again or contact the maintenance personnel |
Err5 | Water level not met in 8 minutes | Make sure that tap is turned on, and water pressure is normal. If problem still exists, please contact the maintenance personnel |
Err7 | Motor overheat protection or damage | Contact the maintenance personnel |
Err8 | Water exceeds protective level | |
End | A program ends | |
01:25 | The remaining time is 1hour 25 minutes |
Error code: | Cause: | Correction: |
---|---|---|
Error 1: The door lock light does not illuminate | Door is not properly shut | Shut the door properly |
Error 2: The door lock light glitters 2 times and stops 4 seconds repeatedly | Drainage error, water not emptied within 4 minutes | Clean the filter and check the drain hose for blockage. If error still exists, please contact the maintenance personnel |
Error 3: The door lock light glitters 3 times and stops 4 seconds repeatedly | Temperature sensor not properly connected or damaged | Contact the maintenance personnel |
Error 4: The door lock light glitters 4 times and stops 4 seconds repeatedly | Heating coil damage leads to a failure to reach the set temperature within the specified time (This message is display at the end of a program). | |
Error 5: The door lock light glitters 5 times and stops 4 seconds repeatedly | Water level not met in 8 minutes | Make sure that tap is turned on, and water pressure is normal |
If problem still exists, please contact the maintenance personnel | ||
Error 6: The door lock light glitters 6 times and stops 4 seconds repeatedly | Timing control silicon damage | Contact the maintenance personnel |
Error 7: The door lock light glitters 7 times and stops 4 seconds repeatedly | Motor overheat protection or damage | |
Error 8: The door lock light glitters 8 times and stops 4 seconds repeatedly | Water exceeds protective level |
A leak error. To fix a leak, do the following: Locate damaged hoses and replace…
To fix the error, you can try the following steps: Make sure the hoses are…
When it comes to reliable home appliances, Bosch is a brand that quickly comes to…
The Bosch dishwasher, a renowned name in the realm of kitchen appliances, has earned its…
Understanding the complexities of modern appliances like the Samsung dishwasher can be a daunting task.…
Kitchen appliances such as dishwashers are vital tools that help make our lives easier. Among…